‹ALARMSMazatrol Assistant
PARAMUser parameter · EIA/ISO (F)
F94

EIA/ISO bit settings (8 bits)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.
Bit settings — F94 is set bit by bit
  1. bit 0

    Movement to hole-drilling position in fixed-cycle mode

    0: According to the selected modal mode (G00 or G01) 1: Fixed as rapid traverse mode (G00)

    Range 0, 1 · Takes effect: At power on

  2. bit 1

    External deceleration signal valid/invalid

    0: External deceleration signal enabled 1: External deceleration signal disabled

    Range 0, 1 · Takes effect: At power on

  3. bit 2

    Tool length offset cancellation upon zero point return by G28/G30 or manual operation, enabled/disabled

    0: Cancel 1: Do not cancel

    Range 0, 1 · Takes effect: At power on

  4. bit 3

    Modal at power-on or at reset (G01/G00)

    0: G01 (linear interpolation) 1: G00 (positioning)

    Range 0, 1 · Takes effect: At power on

  5. bit 4

    Tool command method using T-codes

    0: To specify the group number on the TOOL DATA display 1: To specify the tool number (or pocket number)

    Range 0, 1 · Takes effect: At power on

  6. bit 5

    Fixed value (0)

  7. bit 6

    Fixed value (1)

  8. bit 7

    Tool offset amount effectuated in an EIA/ISO program

    0: Offsets on the TOOL OFFSET display enabled 1: EIA/ISO offsets on the TOOL DATA display enabled

    Range 0, 1 · Takes effect: At power on

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 35, 209, 210, 211. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →