What does Mazak parameter J144 do?

J144 is a Machine parameter in the CALL MACRO group of the MAZATROL SmoothX control (INTEGREX e-670H). 2 bit settings.

Which bits does Mazak parameter J144 have?

Bit 0: Tool interference check type Bit 2: Tool life data overwrite during automatic operation

PARAMMachine parameter · CALL MACRO (J)

J144

CALL MACRO bit settings (2 bits)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

Bit settings — J144 is set bit by bit

bit 0
Tool interference check type
Tool interference check type on the TOOL DATA display 0: Magazine-type tool interference check 1: Tool interference check using Racklayout.txt
Range 0, 1 · Takes effect: At power on
bit 2
Tool life data overwrite during automatic operation
Overwriting of tool life data (maximum allowable wear, life time, use time, life count, use count) when parameter L57 is set to 1 (tool data overwriting during automatic operation valid) 0: Possible 1: Impossible
Range 0, 1 · Takes effect: Immediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 60, 392, 393. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →