‹ALARMSMazatrol Assistant
PARAMMachine parameter · MEASURE (K)
K102

MEASURE bit settings (7 bits)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.
Bit settings — K102 is set bit by bit
  1. bit 0

    Fixed value (0)

  2. bit 2

    Fixed value (0)

  3. bit 3

    Compensation method for the sensing tool’s eccentricity and stylus radius in workpiece measurement and coordinate measurement, M Pro compatible/New scheme

    How to use the data of compensation for the sensing tool’s eccentricity and stylus radius in workpiece measurement and coordinate measure- ment. 0: M Pro scheme For workpiece measurement: No use of eccentricity settings; Use of stylus radius settings for both longitudinal (workpiece-axial) and transverse (workpiece-radial) directions. For coordinate measurement: Use of eccentricity setting for the direc- tion of measuring feed; Use of stylus radius setting for transverse (workpiece-radial) direction. 1: New scheme Full use of the eccentricity and stylus radius settings for both work- piece measurement and coordinate measurement. * Setting of this parameter and compensation method Workpiece 0 Invalid Invalid Valid Valid measurement Coordinate 0 Valid Invalid Invalid Valid measurement

    Range 0, 1 · Takes effect: Immediate

  4. bit 4

    Z-axis direction for setting the TPC relay points of a measurement unit

    Z-axis direction for setting the TPC relay points for a measurement unit. 0: Direction opposite to the program coordinate system 1: Direction of the program coordinate system

    Range 0, 1 · Takes effect: Immediate

  5. bit 5

    Selection of setup data (jaw data and tailstock position) to be used in EIA/ISO programs

    Barrier information for EIA/ISO programs is to be set 0: in the relevant parameters, 1: on the SET UP MANAGE. display.

    Range 0, 1 · Takes effect: Immediate

  6. bit 6

    Setting the direction of rotation for milling tools mounted on the turret

    Whether or not, on the TOOL DATA display, the direction of rotation can be specified for milling tools mounted on the turret. 0: No 1: Yes (Forward/Reverse)

    Range 0, 1 · Takes effect: At power on

  7. bit 7

    Fixed value (0)

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 65, 66, 430, 431. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →