‹ALARMSMazatrol Assistant
PARAMMachine parameter · MEASURE (K)
K107

MEASURE bit settings (5 bits)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.
Bit settings — K107 is set bit by bit
  1. bit 0

    Fixed value (0)

  2. bit 4

    Corner judgment halfway through a block during polar coordinate interpolation where rotary axis shape correction is valid

    Polar coordinate interpolation in the condition that the rotational axis shape correction is valid 0: Corner judgment halfway through a block 1: No corner judgment halfway through a block * When this parameter is set to 1, the machine will undergo hard acceleration when the moving axis changes partway through a block, which may cause machine vibrations. * When this parameter is set to 0, optimum acceleration control works during the operation of a block. In this condition, if the feed rate is high, it may slow down at corners and the machining cycle time may be longer.

    Range 0, 1 · Takes effect: At power on

  3. bit 5

    Motion distance in the manual pulse feed mode for the axis whose position is displayed in diameter value

    0: In radius values 1: In diameter values * Invalid for the axis for which bit 5 of M18 is set to 1.

    Range 0, 1 · Takes effect: After stop of movement

  4. bit 6

    Deceleration for arc valid/invalid

    Range 0, 1 · Takes effect: At power on

  5. bit 7

    Fixed value (0)

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 67, 436, 437. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →