What is the setting range of Mazak parameter K3?

3 to 13. A changed value takes effect: Immediate.

PARAMMachine parameter · MEASURE (K)

Identification number of the shaping control axis

Q: What does Mazak parameter K3 do?

K3 is a Machine parameter in the MEASURE group of the MAZATROL SmoothX control (INTEGREX e-670H). Identification number of the shaping control axis. Set identification number of the shaping control axis. Specify the identification number of the shaping control axis as follows according to the value set at parameter K105 bit 6 (handling of the shaping control axis) Example : X Y Z B C V When there is an axis for which data is not set on the MACHINE PARAMETER display (“FEED VEL.” (M), “TIME CONST.” (N), etc.), where the axis data is set, as shown below, set the identification number of the shaping axis as follows: If the value set at parameter K105 bit 6 is: “0”, set “6”. Counting of the axis number starts with “1” and the axis for which the data is not set is not included when counting the axis number. “1”, set “7”. Counting of the axis number starts with “1” and the axis for which the data is not set is included when counting the axis number. Note : Set the type of the axis which has been set on this parameter to the rotational axis (M17 bit 4 = 1).

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

Set identification number of the shaping control axis. Specify the identification number of the shaping control axis as follows according to the value set at parameter K105 bit 6 (handling of the shaping control axis) Example : X Y Z B C V When there is an axis for which data is not set on the MACHINE PARAMETER display (“FEED VEL.” (M), “TIME CONST.” (N), etc.), where the axis data is set, as shown below, set the identification number of the shaping axis as follows: If the value set at parameter K105 bit 6 is: “0”, set “6”. Counting of the axis number starts with “1” and the axis for which the data is not set is not included when counting the axis number. “1”, set “7”. Counting of the axis number starts with “1” and the axis for which the data is not set is included when counting the axis number. Note : Set the type of the axis which has been set on this parameter to the rotational axis (M17 bit 4 = 1).

Setting

Setting range3 to 13

Unit—

Program typeE

Takes effectImmediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 61, 400. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →