What does Mazak parameter K68 do?

K68 is a Machine parameter in the MEASURE group of the MAZATROL SmoothX control (INTEGREX e-670H). 6 bit settings.

Which bits does Mazak parameter K68 have?

Bit 0: Coordinate system with reference to which the offset amounts are to be used in tool length offset for the selected machining surface (For machines of five-surface machining by angular tools) Bit 1: Speed clamping method for polar coordinate interpolation Bit 3: Fixed value (0) Bit 4: Fixed value (0) Bit 5: Override/dryrun speed valid/invalid when the G31 command is issued Bit 7: Whether all the barrier cancel data in the program is to be cleared by executing the MMS unit in a MAZATROL program

‹ALARMSMazatrol Assistant

PARAMMachine parameter · MEASURE (K)

K68

MEASURE bit settings (6 bits)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

Bit settings — K68 is set bit by bit

bit 0
Coordinate system with reference to which the offset amounts are to be used in tool length offset for the selected machining surface (For machines of five-surface machining by angular tools)
Coordinate system with reference to which the offset amounts are to be used in tool length offset for the selected machining surface. (For machines of five-surface machining by angular tools) 0: Machine coordinate system 1: Workpiece coordinate system
Range 0, 1 · Takes effect: Immediate
bit 1
Speed clamping method for polar coordinate interpolation
Speed clamping method for polar coordinate interpolation 0: Virtual axis clamp: C-axis speed in /min specified by M1/M3 is converted into mm/min. Actual axis clamp: C-axis rapid feed or cutting feed rate is clamped to M3. 1: Virtual axis clamp: The X-axis speed specified by M1/M3 is used for the C-axis. Actual axis clamp: C-axis rapid feed rate is clamped to M1 and the cutting feed rate is clamped to M3.
Range 0, 1 · Takes effect: Immediate
bit 3
Fixed value (0)
bit 4
Fixed value (0)
bit 5
Override/dryrun speed valid/invalid when the G31 command is issued
0 : Invalid 1 : Valid
Range 0, 1 · Takes effect: Immediate
bit 7
Whether all the barrier cancel data in the program is to be cleared by executing the MMS unit in a MAZATROL program
0: Invalid 1: Valid
Range 0, 1 · Takes effect: Immediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 63, 414, 415. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →