‹ALARMSMazatrol Assistant
PARAMMachine parameter · MEASURE (K)
K96

MEASURE bit settings (8 bits)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.
Bit settings — K96 is set bit by bit
  1. bit 0

    G0 command in-position check valid/invalid

    Takes effect: After stop of movement

  2. bit 1

    Timing of manual free feed finish signal

    Takes effect: After stop of movement

  3. bit 2

    Fixed value (0)

    Takes effect: After stop of movement

  4. bit 3

    Axis/Cutting interlock alarm display, valid/invalid

    Takes effect: After stop of movement

  5. bit 4

    Suppression of lost motion in modes other than the G1 command mode, valid/invalid

    Takes effect: After stop of movement

  6. bit 5

    Fixed value (0)

    Takes effect: After stop of movement

  7. bit 6

    Fixed value (0)

    Takes effect: After stop of movement

  8. bit 7

    Fixed G0 inclination

    Takes effect: After stop of movement

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 65, 428. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →