What is the setting range of Mazak parameter L4?

0 to ±99999999 (unit: 0.0001 mm/0.00001 in). A changed value takes effect: At power on.

PARAMMachine parameter · TABLE (L)

Radius of stylus ball of touch sensor (Y-component)

Q: What does Mazak parameter L4 do?

L4 is a Machine parameter in the TABLE group of the MAZATROL SmoothX control (INTEGREX e-670H). Radius of stylus ball of touch sensor (X-component). The true radius value of the stylus ball of the touch sensor Note : These data are automatically set when calibration measurement is performed using the MMS unit.

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

Radius of stylus ball of touch sensor (X-component)

The true radius value of the stylus ball of the touch sensor Note : These data are automatically set when calibration measurement is performed using the MMS unit.

Setting

Setting range0 to ±99999999

Unit0.0001 mm/0.00001 in

Program typeM

Takes effectAt power on

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 70, 462. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →