PARAMMachine parameter · TABLE (L)
L71
Shift of basic coordinate for oblique face machining
Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.
What it does
Shift of basic coordinate for oblique face machining
For execution of the program for oblique face machining, specify to execute or not machining on the coordinate that is turned from the basic coordinate (set in WPC unit or in OFFSET unit) at an angle of the correction value for the B-axis. 0: Machining on the coordinate that is turned from the basic coordinate at an angle of the correction value for the B-axis 1: Machining on the basic coordinate specified in the program
Setting
Setting range1, 0
Unit—
Program typeM, E
Takes effectImmediate
Source
Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 73, 479. Reference and explanation only — not a reproduction of the manual.