What is the setting range of Mazak parameter L77?

0 to 30 (unit: °). A changed value takes effect: After stop of axis movement.

PARAMMachine parameter · TABLE (L)

L77

Angle for deceleration at corner before interpolation

Q: What does Mazak parameter L77 do?

L77 is a Machine parameter in the TABLE group of the MAZATROL SmoothX control (INTEGREX e-670H). Angle for deceleration at corner before interpolation. Set an angle for decelerating cutting feed rate at a corner. Input of 0 is regarded as 5°. Setting at an angle higher than 30° is disposed as 30°.

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

Set an angle for decelerating cutting feed rate at a corner. Input of 0 is regarded as 5°. Setting at an angle higher than 30° is disposed as 30°.

Setting

Setting range0 to 30

Unit°

Program typeM, E

Takes effectAfter stop of axis movement

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 73, 480. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →