What is the setting range of Mazak parameter M1?

0 to 600000 (unit: mm/min (°/min)). A changed value takes effect: After stop of movement.

PARAMMachine parameter · FEED VEL. (M)

Rapid feed rate

Q: What does Mazak parameter M1 do?

M1 is a Machine parameter in the FEED VEL. group of the MAZATROL SmoothX control (INTEGREX e-670H). Rapid feed rate. The feed rate for moving each axis under the G00 command during automatic operation The feed rate for moving each axis in either the manual rapid feed mode or the zero-point return mode Note : Initial zero-point return is performed at the feed rate set in parameter M2.

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

Rapid feed rate

The feed rate for moving each axis under the G00 command during automatic operation The feed rate for moving each axis in either the manual rapid feed mode or the zero-point return mode Note : Initial zero-point return is performed at the feed rate set in parameter M2.

Setting

Setting range0 to 600000

Unitmm/min (°/min)

Program typeM, E

Takes effectAfter stop of movement

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 77, 505. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →