What does Mazak parameter M19 do?

M19 is a Machine parameter in the FEED VEL. group of the MAZATROL SmoothX control (INTEGREX e-670H). 5 bit settings.

Which bits does Mazak parameter M19 have?

Bit 0: Transmission of rapid feed rate value to SV69/SV70 Bit 3: In-position checking method Bit 4: Parameter for system internal setting Setting prohibited Bit 5: Zero-point operation starting position check Bit 7: Backlash scheme to be adopted for dog-type returning to zero point

‹ALARMSMazatrol Assistant

PARAMMachine parameter · FEED VEL. (M)

M19

FEED VEL. bit settings (5 bits)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

Bit settings — M19 is set bit by bit

bit 0
Transmission of rapid feed rate value to SV69/SV70
Set whether or not the value of parameter M1 (rapid feed rate) is transmitted to servo parameter at power-on. 0 : Transmit (same as before) 1 : Do not transmit
Range 0, 1 · Takes effect: At power on
bit 3
In-position checking method
0 : NC 1 : Servo
Range 0, 1 · Takes effect: At power on
bit 4
Parameter for system internal setting Setting prohibited
bit 5
Zero-point operation starting position check
0: No check 1: Alarm if returned from the dog
Range 0, 1 · Takes effect: At power on
bit 7
Backlash scheme to be adopted for dog-type returning to zero point
0 : G01 1 : G00
Range 0, 1 · Takes effect: At power on

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 79, 511, 512. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →