What is the setting range of Mazak parameter M30?

0 to 600000 (unit: mm/min). A changed value takes effect: After stop of axis movement.

PARAMMachine parameter · FEED VEL. (M)

M30

Rapid feed clamping speed 2 for superposition control

Q: What does Mazak parameter M30 do?

M30 is a Machine parameter in the FEED VEL. group of the MAZATROL SmoothX control (INTEGREX e-670H). Rapid feed clamping speed 2 for superposition control. Set the rapid feed clamping speed for superposition control when both the reference axis and superposition axis move at a rapid feed rate and in the same direction (see the Note). (Set value for the reference axis and superposition axis to be used during superposition control.)  Set M29 to M31 so that the following conditions are satisfied: M29 (RA) + M31 (SA)  M1 (SA) M31 (RA) + M29 (SA)  M1 (SA) M30 (RA) + M30 (SA)  M1 (SA) RA: reference axis M31 (RA) + M31 (SA)  M1 (SA) SA: superposition axis Note : Whether the axes move in the same direction or in different directions is judged from the command and polarity (parameter N21, bit 6).

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

Set the rapid feed clamping speed for superposition control when both the reference axis and superposition axis move at a rapid feed rate and in the same direction (see the Note). (Set value for the reference axis and superposition axis to be used during superposition control.)  Set M29 to M31 so that the following conditions are satisfied: M29 (RA) + M31 (SA)  M1 (SA) M31 (RA) + M29 (SA)  M1 (SA) M30 (RA) + M30 (SA)  M1 (SA) RA: reference axis M31 (RA) + M31 (SA)  M1 (SA) SA: superposition axis Note : Whether the axes move in the same direction or in different directions is judged from the command and polarity (parameter N21, bit 6).

Setting

Setting range0 to 600000

Unitmm/min

Program typeM, E

Takes effectAfter stop of axis movement

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 80, 518. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →