What is the setting range of Mazak parameter M31?

0 to 600000 (unit: mm/min). A changed value takes effect: After stop of axis movement.

PARAMMachine parameter · FEED VEL. (M)

M31

Cutting feed clamping speed for superposition control

Q: What does Mazak parameter M31 do?

M31 is a Machine parameter in the FEED VEL. group of the MAZATROL SmoothX control (INTEGREX e-670H). Cutting feed clamping speed for superposition control. Set the cutting feed clamping speed for superposition control. (Set value for the reference axis and superposition axis to be used during superposition control.)  Set M29 to M31 so that the following conditions are satisfied: M29 (RA) + M31 (SA)  M1 (SA) M31 (RA) + M29 (SA)  M1 (SA) M30 (RA) + M30 (SA)  M1 (SA) RA: reference axis M31 (RA) + M31 (SA)  M1 (SA) SA: superposition axis

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

Set the cutting feed clamping speed for superposition control. (Set value for the reference axis and superposition axis to be used during superposition control.)  Set M29 to M31 so that the following conditions are satisfied: M29 (RA) + M31 (SA)  M1 (SA) M31 (RA) + M29 (SA)  M1 (SA) M30 (RA) + M30 (SA)  M1 (SA) RA: reference axis M31 (RA) + M31 (SA)  M1 (SA) SA: superposition axis

Setting

Setting range0 to 600000

Unitmm/min

Program typeM, E

Takes effectAfter stop of axis movement

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 80, 518. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →