What is the setting range of Mazak parameter N4?

0 to 455 (unit: ms). A changed value takes effect: After stop of movement.

PARAMMachine parameter · TIME CONST. (N)

Time constant for post-interpolation rapid feed acceleration/deceleration filter

Q: What does Mazak parameter N4 do?

N4 is a Machine parameter in the TIME CONST. group of the MAZATROL SmoothX control (INTEGREX e-670H). Time constant for post-interpolation rapid feed acceleration/deceleration filter. Set the time constant for the filter that further smoothens the speed signal waveform during rapid feed (G0) operation with shape correction off and during rapid feed operation in manual operation mode. The filter will be invalid if 0 is set.

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

Set the time constant for the filter that further smoothens the speed signal waveform during rapid feed (G0) operation with shape correction off and during rapid feed operation in manual operation mode. The filter will be invalid if 0 is set.

Setting

Setting range0 to 455

Unitms

Program typeM, E

Takes effectAfter stop of movement

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 81, 524. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →