What is the setting range of Mazak parameter S14?

0 to 32767 (unit: 0.001 mm). A changed value takes effect: At power on.

PARAMMachine parameter · ANOTHER (S)

S14

G01 in-position width

Q: What does Mazak parameter S14 do?

S14 is a Machine parameter in the ANOTHER group of the MAZATROL SmoothX control (INTEGREX e-670H). G01 in-position width. Set the inposition width for G01. The in-position check for G01 is effective when one of G09 (exact stop check), G61 (exact stop check mode) and the error detection is selected with the parameter K95 bit 7 set to 1. For utilizing the in-position width for G01, set the in-position width of the servo parameter to 0 to avoid trouble. Note : 1. This parameter is valid only when bit 3 of M19 is 0. 2. Setting a value outside 0 to 32767 assumes S14 = 50.

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

Set the inposition width for G01. The in-position check for G01 is effective when one of G09 (exact stop check), G61 (exact stop check mode) and the error detection is selected with the parameter K95 bit 7 set to 1. For utilizing the in-position width for G01, set the in-position width of the servo parameter to 0 to avoid trouble. Note : 1. This parameter is valid only when bit 3 of M19 is 0. 2. Setting a value outside 0 to 32767 assumes S14 = 50.

Setting

Setting range0 to 32767

Unit0.001 mm

Program typeM, E

Takes effectAt power on

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 83, 536. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →