What does Mazak parameter SA45 do?

SA45 is a Machine parameter in the SPINDLE group of the MAZATROL SmoothX control (INTEGREX e-670H). 7 bit settings.

Which bits does Mazak parameter SA45 have?

Bit 0: Spindle speed range changing method, in relation to switching the torque factors for auto-pecking of the cutting load detection type Bit 1: Spindle speed range changing method, in relation to switching the torque factors for auto-pecking of the cutting load detection type 2 Bit 2: Homing direction for synchronous tapping Bit 3: Homing direction for synchronous tapping Bit 4: Defines the specified direction as the Z-phase detection direction Bit 5: Spindle index gear correction Bit 6: Selection of spindle removal

‹ALARMSMazatrol Assistant

PARAMMachine parameter · SPINDLE (SA)

SA45

SPINDLE bit settings (7 bits)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

Bit settings — SA45 is set bit by bit

bit 0
Spindle speed range changing method, in relation to switching the torque factors for auto-pecking of the cutting load detection type
0: As specified by bit 1 1: L/H coil sw. + Mecha. gear shift * For the setting of SA45 bit 0 = 1, set the rated torque, viscous & coulomic friction coefficients of the spindle motor in the relevant parameters as tabulated below: Speed Rated Visc. fric. Coul. fric. range No. torque coef. coef.
Range 0, 1 · Takes effect: After stop of movement
bit 1
Spindle speed range changing method, in relation to switching the torque factors for auto-pecking of the cutting load detection type 2
0: L/H coil switching scheme 1: Mecha-gear scheme (Only when 0 is set up at bit 0) * Bit 1 is valid only when bit 0 = 0.
Range 0, 1 · Takes effect: After stop of movement
bit 2
Homing direction for synchronous tapping
bit 3
Homing direction for synchronous tapping
00: Shorter route 01: Forward rotation 10: Reverse rotation
Range 0, 1 · Takes effect: After stop of movement
bit 4
Defines the specified direction as the Z-phase detection direction
Defines the specified direction as the Z-phase detection direction.
Range 0, 1 · Takes effect: After stop of movement
bit 5
Spindle index gear correction
0: Invalid 1: Valid
Range 0, 1 · Takes effect: After stop of movement
bit 6
Selection of spindle removal
0: Invalid 1: Valid
Range 0, 1 · Takes effect: After stop of movement

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 85, 551, 552, 553. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →