PARAMMachine parameter · SPINDLE (SA)
SA53
Spindle 1/4h (1/2h) rated torque for auto-pecking of the cutting load detection type — L coils
Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.
What it does
Spindle 1/4h (1/2h) rated torque for auto-pecking of the cutting load detection type — L coils
Set the 1/4h (1/2h) rated torque for the L coils of the spindle motor. Note : 1. Only the 1/2h rated torque, not the 1/4h rated torque, may be known for the particular motor. If that is the case, set the 1/2h rated torque. If coil selection is not possible for the spindle, enter the same value in both SA53 and SA54. An alarm will result if 0 is entered even in either one of the two parameters. 2. If bit 1 in SA45 is set to 1, set the 1/4h rated torque applied when the spindle motor gear position is 1.
Setting
Setting range0 to 65535
Unit0.1 N·m
Program typeM
Takes effectImmediate
Source
Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 86, 555. Reference and explanation only — not a reproduction of the manual.