What is the setting range of Mazak parameter SA55?

0 to 65535 (unit: 0.1 N·m). A changed value takes effect: Immediate.

PARAMMachine parameter · SPINDLE (SA)

SA55

Spindle 1/4h (1/2h) rated torque for auto-pecking of the cutting load detection type — Spindle gear position 3

Q: What does Mazak parameter SA55 do?

SA55 is a Machine parameter in the SPINDLE group of the MAZATROL SmoothX control (INTEGREX e-670H). Spindle 1/4h (1/2h) rated torque for auto-pecking of the cutting load detection type — Spindle gear position 3. Set the 1/4h rated torque applied when the spindle motor gear position is 3. Note : 1. Only the 1/2h rated torque, not the 1/4h rated torque, may be known for the particular motor. If that is the case, set the 1/2h rated torque. 2. This parameter is valid only when the setting of bit 1 in SA45 is 1.

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

Set the 1/4h rated torque applied when the spindle motor gear position is 3. Note : 1. Only the 1/2h rated torque, not the 1/4h rated torque, may be known for the particular motor. If that is the case, set the 1/2h rated torque. 2. This parameter is valid only when the setting of bit 1 in SA45 is 1.

Setting

Setting range0 to 65535

Unit0.1 N·m

Program typeM

Takes effectImmediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 86, 555. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →