What is the setting range of Mazak parameter SA58?

±99999999. A changed value takes effect: Immediate.

PARAMMachine parameter · SPINDLE (SA)

SA58

Spindle viscous friction coefficient “cms” for auto-pecking of the cutting load detection type — Range 2

Q: What does Mazak parameter SA58 do?

SA58 is a Machine parameter in the SPINDLE group of the MAZATROL SmoothX control (INTEGREX e-670H). Spindle viscous friction coefficient “cms” for auto-pecking of the cutting load detection type — Range 1. If the “fms” value depends on spindle speeds, specify the gradient. Example : If “fms” is 90000 for an “S” value of 5000 and 140000 for S10000: Since “cms” = (140000 – 90000) / (10000 – 5000) = 10, set “10” in the above example. Note : Set the spindle viscous friction coefficient “cms” when SA45 bit 0 = 1. (Enter, moreover, 1000 times the respective calculation results in this case.)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

Spindle viscous friction coefficient “cms” for auto-pecking of the cutting load detection type — Range 1

If the “fms” value depends on spindle speeds, specify the gradient. Example : If “fms” is 90000 for an “S” value of 5000 and 140000 for S10000: Since “cms” = (140000 – 90000) / (10000 – 5000) = 10, set “10” in the above example. Note : Set the spindle viscous friction coefficient “cms” when SA45 bit 0 = 1. (Enter, moreover, 1000 times the respective calculation results in this case.)

Setting

Setting range±99999999

Unit—

Program typeM

Takes effectImmediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 86, 557. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →