What does Mazak parameter SU158 do?

SU158 is a User parameter in the SYSTEM group of the MAZATROL SmoothX control (INTEGREX e-670H). 7 bit settings.

Which bits does Mazak parameter SU158 have?

Bit 0: Tool change position during TOOL EYE measurement Bit 1: Conditions for wear compensation of turning tools in manual program unit Bit 2: Checking the rotational axes’ correction values in workpiece placement error correction for MAZATROL programs Bit 3: Handling of G43P0 tool length compensation with a touch sensor Bit 4: Fixed value (0) Bit 5: Returning operation from the chopping reference point Bit 7: Manual tool measurement tool wear offset clear function

‹ALARMSMazatrol Assistant

PARAMUser parameter · SYSTEM (SU)

SU158

SYSTEM bit settings (7 bits)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

Bit settings — SU158 is set bit by bit

bit 0
Tool change position during TOOL EYE measurement
When executing tool measurement, use the TOOL EYE tool change position (SU118 to SU121) for tool change. 0: Invalid 1: Valid
Range 0, 1 · Takes effect: Immediate
bit 1
Conditions for wear compensation of turning tools in manual program unit
0: Wear compensation valid for XYZ if any one axis is specified 1: Wear compensation valid for the specified axis
Range 0, 1 · Takes effect: Immediate
bit 2
Checking the rotational axes’ correction values in workpiece placement error correction for MAZATROL programs
0: Invalid 1: Valid Note : Admissible motion ranges are to be specified in and respectively for the primary and secondary rotational axis.
Range 0, 1 · Takes effect: Immediate
bit 3
Handling of G43P0 tool length compensation with a touch sensor
0: Tool length compensation for turning tools 1: Tool length compensation for milling tools * However, this is always used for tool length compensation for milling tools when bit 7 of parameter F94 is set to 0 and bit 1 of parameter
Range 0, 1 · Takes effect: Immediate
bit 4
Fixed value (0)
bit 5
Returning operation from the chopping reference point
Set the speed to use when returning from the chopping top dead point to the chopping reference point. 0: Chopping speed 1: Rapid feed rate
Range 0, 1 · Takes effect: Immediate
bit 7
Manual tool measurement tool wear offset clear function
0: Invalid 1: Valid
Range 0, 1 · Takes effect: Immediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 49, 314, 315. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →