PARAMUser parameter · TURNING (TC)
TC12
Deceleration rate at cutting end in turning-drilling unit
Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.
What it does
Deceleration rate at cutting end in turning-drilling unit
F’ = F × F : Specified feed rate F' : Feed rate at cutting start Feed rate at F' to the point distant by = + (0° < < 80°)
Setting
Setting range0 to 100
Unit%
Program typeM
Takes effectImmediate
Source
Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 50, 320. Reference and explanation only — not a reproduction of the manual.