What is the setting range of Mazak parameter TC14?

0 to 100 (unit: %). A changed value takes effect: Immediate.

PARAMUser parameter · TURNING (TC)

TC14

Maximum permissible rate of increase of the initial cutting depth during roughing

Q: What does Mazak parameter TC14 do?

TC14 is a User parameter in the TURNING group of the MAZATROL SmoothX control (INTEGREX e-670H). Maximum permissible rate of increase of the initial cutting depth during roughing. This parameter is valid during initial cutting in a bar roughing cycle. If the remainder obtained by dividing the thickness of cutting during the roughing cycle by the corresponding cutting depth stays within the range specified by this parameter, that value will be added to the initial cutting depth to reduce the cutting repeat times. Example : 1. TC14 = 0 2. TC14 = 10% (R-depth.: 5) (R-depth.: 5) 10.1 10.1 Cutting to a depth of 10.1 Cutting at a depth setting of 5 results is executed in 3 rounds of in a final cutting depth of 0.1. Since cutting (5, 5, and 0.1). 10% of the depth setting of 5 is 0.5 and this value is larger than the final cutting depth, this final cutting depth is added to the initial cutting depth. Note : Up to 100% can be set. When a value larger than 100% is set, it is regarded as 0.

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

This parameter is valid during initial cutting in a bar roughing cycle. If the remainder obtained by dividing the thickness of cutting during the roughing cycle by the corresponding cutting depth stays within the range specified by this parameter, that value will be added to the initial cutting depth to reduce the cutting repeat times. Example : 1. TC14 = 0 2. TC14 = 10% (R-depth.: 5) (R-depth.: 5) 10.1 10.1 Cutting to a depth of 10.1 Cutting at a depth setting of 5 results is executed in 3 rounds of in a final cutting depth of 0.1. Since cutting (5, 5, and 0.1). 10% of the depth setting of 5 is 0.5 and this value is larger than the final cutting depth, this final cutting depth is added to the initial cutting depth. Note : Up to 100% can be set. When a value larger than 100% is set, it is regarded as 0.

Setting

Setting range0 to 100

Unit%

Program typeM

Takes effectImmediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 50, 321. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →