TURNING bit settings (4 bits)

1. bit 4

   Selection of compensation cancel when working around the workpiece

   Change the timing of cancelling the amount of wear compensation (tool offset number set in TPC or wear compensation in tool data) when working around the workpiece with a turning tool mounted. 0: Cancel compensation when working around the workpiece Clearance area 1: Cancel compensation after working around the workpiece Clearance area

   Range 0, 1 · Takes effect: Immediate

2. bit 5

   Selection of movement from the clearance area to a clearance point during O.D. turning

   Movement onto a clearance point when the tool tip after O.D. turning is located within the clearance area around the workpiece 0: Do not move 1: Move * Operation with this parameter set to 1 (ON) Clearance area

   Range 0, 1 · Takes effect: Immediate

3. bit 6

   Selection of movement from the clearance area to a clearance point during face/rear turning

   Movement onto a clearance point when the tool tip after face/rear turning is located within the clearance area around the workpiece 0: Do not move 1: Move To the rear To the front Move onto a Clearance area clearance point

   Range 0, 1 · Takes effect: Immediate

4. bit 7

   W-axis command enabled/disabled during two-workpiece machining

   W-axis command from the lower turret when upper - head 1 and lower -head 2 is set in two-workpiece machining unit 0: Impossible 1: Possible (using address B) * The W-axis command can be issued using G110 (cross command) and address B regardless of parameters except for two-workpiece machining unit.

   Range 0, 1 · Takes effect: Immediate

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 55, 360, 361. Reference and explanation only — not a reproduction of the manual.