What is the setting range of Mazak parameter TC3?

0 to 500 (unit: %). A changed value takes effect: Immediate.

PARAMUser parameter · TURNING (TC)

TC3

Acceleration rate in up-going wall slope (90°) for rough cutting in bar machining unit

Q: What does Mazak parameter TC3 do?

TC3 is a User parameter in the TURNING group of the MAZATROL SmoothX control (INTEGREX e-670H). Acceleration rate in up-going wall slope (90°) for rough cutting in bar machining unit. F1 : Feed rate for rough cutting F2 = F1 × Note : Up to 500 % can be set. This is effective only when (bit 0) = 1.

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

F1 : Feed rate for rough cutting F2 = F1 × Note : Up to 500 % can be set. This is effective only when (bit 0) = 1.

Setting

Setting range0 to 500

Unit%

Program typeM

Takes effectImmediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 50, 317. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →