What is the setting range of Mazak parameter TC53?

0 to 65535 (unit: mm/min / 0.1 in/min). A changed value takes effect: Immediate.

PARAMUser parameter · TURNING (TC)

TC53

Feed rate for escape by short distance

Q: What does Mazak parameter TC53 do?

TC53 is a User parameter in the TURNING group of the MAZATROL SmoothX control (INTEGREX e-670H). Feed rate for escape by short distance. For escape by very short distance, G01 feed speed will be faster than G00 to complete the operation. (If G00 is used, smoothing 0 detection will be made at the end position.) Therefore, for escape very short distance, use G01 command, and set the feed speed of this command as parameter. Example : Escape in finish Escape in rough cutting cutting of edge-machining unit of bar machining unit [1] [1]: Feed speed in this block Escape distance (TC67, TC68)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

For escape by very short distance, G01 feed speed will be faster than G00 to complete the operation. (If G00 is used, smoothing 0 detection will be made at the end position.) Therefore, for escape very short distance, use G01 command, and set the feed speed of this command as parameter. Example : Escape in finish Escape in rough cutting cutting of edge-machining unit of bar machining unit [1] [1]: Feed speed in this block Escape distance (TC67, TC68)

Setting

Setting range0 to 65535

Unitmm/min / 0.1 in/min

Program typeM

Takes effectImmediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 51, 333. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →