What is the setting range of Mazak parameter TC9?

0 to 100 (unit: %). A changed value takes effect: Immediate.

PARAMUser parameter · TURNING (TC)

TC9

Rough cutting residue ratio in cutting off cycle in groove cutting unit

Q: What does Mazak parameter TC9 do?

TC9 is a User parameter in the TURNING group of the MAZATROL SmoothX control (INTEGREX e-670H). R o u g h c u t ti n g r e s i d u e r a ti o in cutting off cy c le in g r o o v e c u t ti n g u n i t. [1] Cutting at rough cutting feed rate to a point short of end point P by distance d [2] Cutting off at finish cutting feed rate to end point P

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

R o u g h c u t ti n g r e s i d u e r a ti o in cutting off cy c le in g r o o v e c u t ti n g u n i t

[1] Cutting at rough cutting feed rate to a point short of end point P by distance d [2] Cutting off at finish cutting feed rate to end point P

Setting

Setting range0 to 100

Unit%

Program typeM

Takes effectImmediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 50, 319. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →