PARAMUser parameter · TURNING (TC)
TC99
ATC operation after machining when not specified in the end unit
Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.
What it does
ATC operation after machining when not specified in the END unit
Specify the ATC operation after machining when the ATC item in the end unit is not set. TC99 = 0: The same operation as when the item is set to “0” is followed. (The tool is not returned.) TC99 = 1: The same operation as when the item is set to “1” is followed. (The tool is returned and axes move to the returning position.) TC99 = 2: The same pattern as when the item is set to “2” is followed. (The axes move to the returning position and the tool is returned). The setting is regarded as “0” if out of range.
Setting
Setting range0 to 2
Unit—
Program typeM
Takes effectImmediate
Source
Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 53, 345. Reference and explanation only — not a reproduction of the manual.